Zero Grounds :: Homemade Bolt Together Recumbent Bike

Result of 10 voters
Key - Excellent: 5 points; Very Good: 4 points; Good: 3 points; Average: 2 points; Poor: 1 points; (Average points in brackets)

(1)	Drive stalk insert. This is a steering tube insert. It has been sawed off to have the same angle at both ends. The tip cams were wallowed out to accept a 5/16 carriage bolt. Inside the fork a 1/2" socket wrench was inserted and the nut tightend until the tubes were ovaled. Its a very snug fit, but this will need to be pinned in the final stages of the build. - 4 voters (5.00)
(2)	Here's an option graphic for the finished bike. Totally white trash, and totally worth it. - 3 voters (5.00)
(3)	Finished product. Middle cranks were cut so they won't drag in turns. The steering column was lengthen using the above drive stalk method (using a piece of stock 1/2" galvanized water pipe). - 3 voters (5.00)